![](\"http:\/\/www.tepstar.com\/wordpress\/wp-content\/uploads\/img_0501.jpg\")
<\/p>\n","protected":false},"excerpt":{"rendered":"
2018\/09\/24 Print log HICTOP ABS 0.2mm hot end 230 \u2103 heat bed 90 \u2103 ambient 27.8->30.4 \u2103 Time Temp Note LeftT … \u7d9a\u304d\u3092\u8aad\u3080 Prusa i3 MK3 with hot ambient<\/span>
2018\/09\/24 Print log<\/p>\n
HICTOP ABS 0.2mm hot end 230 \u2103 heat bed 90 \u2103 ambient 27.8->30.4 \u2103<\/p>\n
Time Temp Note LeftT<\/p>\n
16:13 27.8 NC 0% 57min<\/p>\n
16:26 27.8 NC 21% 45min<\/p>\n
16:31 29.2 beep x2 33% 37min<\/p>\n
16:33 29.3 beep x2 35% 36min<\/p>\n
16:42 29.5 beep x2 53% 26min<\/p>\n
16:43 29.5 power down 1 26min<\/p>\n
16:47 29.6 power down 2 22min<\/p>\n
16:59 29.7 beep x2 79% 11min<\/p>\n
17:00 29.8 power down 3 11min<\/p>\n
17:06 29.8 power down x3 4 cooling<\/p>\n
17:09 29.8 beep x2 5min<\/p>\n
17:10 29.8 power down 5<\/p>\n
17:12 29.8 power down 6<\/p>\n
17:19 30.0 power down 7<\/p>\n
17:25 29.9 resure<\/p>\n
17:26 30.1 beep x2 30.4 \u2103 1min<\/p>\n
17:28 30.4 end 0min<\/p>\n
This time there was no thermal runaway during 3D printing,<\/p>\n
but beeps from the power supply and unexplained reset occurred around the temperature exceeding 29.5 degrees Celsius,<\/p>\n
and it began to repeat frequently as the temperature increased.<\/p>\nhttp:\/\/www.tepstar.com\/wordpress\/wp-content\/uploads\/img_0499-1.mov<\/a>\n 2018\/09\/24 Print log HICTOP ABS 0.2mm hot end 230 \u2103 heat bed 90 \u2103 ambient 27.8->30.4 \u2103 Time Temp Note LeftT … \u7d9a\u304d\u3092\u8aad\u3080 Prusa i3 MK3 with hot ambient<\/span> <\/p>\n","protected":false},"excerpt":{"rendered":"